If your vehicle gets stuck in sand,
mud, or snow, call a towing service
to pull it out (see the previous page).
For very short distances, such as
freeing the vehicle, you can use the
detachable towing hook that mounts
on the anchors in the front and rear
bumpers.
Remove the towing hook and
wheel nut wrench placed behind a
cover under the cargo area.
Screw the towing hook into the
hole, and tighten it with the wheel
nut wrench.
Remove the cover, put cloth on the
edge of the cover to prevent
scratches and carefully pry with a
small flat-tip screwdriver or a
metalfingernailfile.
To use the front towing hook:
The cover is attached to the
bumper with a tether.
Remove the rubber cap by pulling
it out.
1.
2.
3.
4.
CONTINUED
If Your Vehicle Gets Stuck
Taking Care of the Unexpected
637
COVER
Front
RUBBER CAP
WHEEL NUT WRENCH
TOWING HOOK
11/08/01 11:14:31 31SZA630_644
To Next Page
Loading...
