HP 1910 User Manual

254
Configuring Switch B
1. Enable LLDP on port GigabitEthernet 1/0/1. (Optional. By default, LLDP is enabled on Ethernet
ports.)
2. Set the LLDP operating mode to Tx on GigabitEthernet 1/0/1:
a. Select Network > LLDP from the navigation tree.
By default, the Port Setup tab is displayed.
b. Click the icon for port GigabitEthernet1/0/1.
The page shown in Figure 218 is displayed.
c. Selec
t Tx from the LLDP Operating Mode list.
3. Click Apply.
A progress dialog box appears.
4. Click Close on the progress dialog box when the progress dialog box prompts that the
configuration succeeds.
Figure 218 Setting the LLDP operating mode to Tx
5. Enable global LLDP:
a. Click the Global Setup tab.
b. Select Enable from the LLDP Enable list.
6. Click Apply.
A progress dialog box appears.
7. Click Close on the progress dialog box when the progress dialog box prompts that the
configuration succeeds.
Verifying the configuration
1. Display the status information of port GigabitEthernet1/0/1 on Switch A:
a. Select Network > LLDP from the navigation tree.

HP 1910 Specifications

General

Model	HP 1910
Category	Switch
Port Type	10/100/1000BASE-T
Layer	Layer 2
PoE Support	No
MAC Address Table Size	8K entries
VLAN Support	Yes
Management	Web-based GUI
Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Jumbo Frame Support	Yes
Ports	24