HP 1910 User Manual

270
Figure 236 Adding GigabitEthernet 1/0/1 to VLAN 100
3. Create VLAN-interface 100:
a. From the navigation tree, select Network > VLAN Interface.
b. Click the Create tab.
c. Enter 100 for VLAN ID.
d. Select the Configure Primary IPv4 Address box.
e. Select the Manual option.
f. Enter 192.168.1.2 for IPv4 Address, and enter 24 or 255.255.255.0 for Mask Length.
g. Click Apply.

HP 1910 Specifications

General

Model	HP 1910
Category	Switch
Port Type	10/100/1000BASE-T
Layer	Layer 2
PoE Support	No
MAC Address Table Size	8K entries
VLAN Support	Yes
Management	Web-based GUI
Switching Capacity	56 Gbps
Forwarding Rate	41.7 Mpps
Jumbo Frame Support	Yes
Ports	24