208
ï‚¡ Configuring the close-wait timer
• Enabling NAT traversal for the CPE
•
Specifying an SSL client policy for HTTPS
connection to ACS
Enabling CWMP from the CLI
You must enable CWMP for other CWMP settings to take effect, whether they are configured from
the CLI, or assigned through the DHCP server or ACS.
To enable CWMP:
1. Enter system view.
system-view
N/A
2. Enter CWMP view.
cwmp
N/A
3. Enable CWMP.
cwmp enable
By default, CWMP is disabled.
Configuring ACS attributes
You can configure two sets of ACS attributes for the CPE: preferred and default.
• The preferred ACS attributes are configurable from the CPE's CLI, the DHCP server, and ACS.
For an attribute, the CLI- and ACS-assigned values have higher priority than the
DHCP-assigned value. The CLI- and ACS-assigned values overwrite each other.
• The default ACS attributes are configurable only from the CLI.
The CPE uses the default ACS attributes for connection establishment only when it is not assigned a
preferred ACS URL from the CLI, ACS, or DHCP server.
Configuring the preferred ACS attributes
Assigning ACS attributes from the DHCP server
You can use DHCP option 43 to assign the ACS URL and ACS login authentication username and
password.
If the DHCP server is an HPE device, you can configure DHCP option 43 by using the option 43 hex
01length URL username password command.
• length—A hexadecimal number that indicates the total length of the length, URL, username,
and password arguments, including the spaces between these arguments. No space is allowed
between the 01 keyword and the length value.
• URL—ACS URL.
• username—Username for the CPE to authenticate to the ACS.
• password—Password for the CPE to authenticate to the ACS.
The ACS URL, username and password must use the hexadecimal format and be space separated.
To Next Page
Loading...
Need help?
General