210
5. (Optional.)
password for authentication
to the default ACS URL.
cwmp acs default password
{
cipher
|
simple
} password
By default, no password has been
configured
the default ACS URL.
Configuring CPE attributes
You can assign CPE attribute values to the CPE from the CPE's CLI or the ACS. The CLI- and
ACS-assigned values overwrite each other, whichever is assigned later.
For more information about the configuration methods supported for each CPE attribute, see
"Configuration task list."
Configuring ACS authentication parameters
To protect the CPE against unauthorized access, configure a CPE username and password for ACS
authentication. When an ACS initiates a connection to the CPE, the ACS must provide the correct
username and password.
The password setting is optional. You may choose to use only a username for authentication.
To configure ACS authentication parameters:
1. Enter system view.
N/A
2. Enter CWMP view.
cwmp
N/A
3. Configure the username for
authentication to the CPE.
cwmp cpe username
username
By default, no username has been
configured
the CPE.
4. (Optional.)
password for authentication
to the CPE.
cwmp cpe password
{
cipher
|
simple
} password
By default, no password has been
configured
the CPE.
Configuring the provision code
The ACS uses the provision code to identify services assigned to each CPE. For correct
configuration deployment, make sure the same provision code is configured on the CPE and the
ACS.
To configure the provision code:
1. Enter system view.
N/A
2. Enter CWMP view.
N/A
3.
code.
cwmp cpe provision-code
provision-code
The default provision code is
PROVISIONINGCODE
.
To Next Page
Loading...
Need help?
General