HPE FlexNetwork 5510 HI Series Network Management And Monitoring Configuration Guide

198
Step
Command
Remarks
action number syslog priority level
facility local-number msg msg
•
Configure an active/standby
switchover action:
action
number
switchover
5. (Optional.) Assig
n a
user role to the policy.
user-role
role-name
By default, a monitor policy
contains user roles that its
creator had at the time of policy
creation.
An EAA policy cannot have both
the
security-audit
user role and
any other user roles. Any
previously assigned user roles
are automatically removed when
you assign the
security-audit
user role to the policy. The
previously assigned
security-audit
user role is
automatically removed when you
assign any other user roles to
the policy..
6. (Optional.) Configure
the policy runtime.
running-time
time
The default runtime is 20
seconds.
7. Enable the policy.
commit
By default, CLI-defined policies
are not enabled.
A CLI-
defined policy can take
effect only after you perform this
step.
Configuring a monitor policy by using Tcl
Step
Command
Remarks
1.
Edit a Tcl script file
(see Table 21).
N/A The supported Tcl version is 8.5.8.
2.
Download the file to
the device by using
FTP or TFTP.
N/A
For more information about using FTP
and TFTP, see Fundamentals
Configuration Guide.
3. Enter system view.
system-view
N/A
4. Create a Tcl-defined
policy and bind it to
the Tcl script file.
rtm tcl-policy
policy-name
tcl-filename
By default, the system does not have Tcl
policies.
This step enables the Tcl-defined policy.
To revise the Tcl script of a policy, you
must suspend all monitor policies first,
and then resume the policies after you
finish revising the script. The system
cannot execute a Tcl-
defined policy if
you edit its Tcl script without suspending
policies.
Write a Tcl script in two lines for a monitor policy, as shown in Table 21.

HPE FlexNetwork 5510 HI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5510 HI Series
Category	Switch
Language	English