HPE FlexNetwork 5510 HI Series

246
<env:Body>
<rpc message-id ="100" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<get-bulk>
<filter type="subtree">
<top xmlns="http://www.hp.com/netconf/data:1.0">
<Ifmgr>
<Interfaces>
<Interface/>
</Interfaces>
</Ifmgr>
</top>
</filter>
</get-bulk>
</rpc>
</env:Body>
</env:Envelope>
How to use NETCONF
You can use NETCONF to manage and configure the device by using the methods in Table 37.
Table 37 NETCONF methods for configuring the device
Configuration tool
Login method
Remarks
CLI
• Console port
• SSH
• Telnet
To implement NETCONF operations, copy valid
NETCONF messages to the CLI in XML view.
This method is suitable for R&D and test
purposes.
Custom configuration tool N/A
To use this method, you must enable
NETCONF over SOAP.
By default, the device cannot interpret custom
configuration tools
' URLs. For the device to
interpret these URLs, you must encode the
NETCONF messages
sent from a custom
configuration tool in SOAP.
Protocols and standards
• RFC 3339, Date and Time on the Internet: Timestamps
• RFC 4741, NETCONF Configuration Protocol
• RFC 4742, Using the NETCONF Configuration Protocol over Secure SHell (SSH)
• RFC 4743, Using NETCONF over the Simple Object Access Protocol (SOAP)
• RFC 5277, NETCONF Event Notifications
• RFC 5381, Experience of Implementing NETCONF over SOAP
• RFC 5539, NETCONF over Transport Layer Security (TLS)
• RFC 6241, Network Configuration Protocol