HPE FlexNetwork 5510 HI Series Network Management And Monitoring Configuration Guide

108
For more information about the ip ttl-expires enable and ip unreachables enable commands, see
Layer 3—IP Services Command Reference.
To configure the path jitter operation:
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Create an NQA operation and
enter NQA operation view.
nqa entry
admin-name
operation-tag
By default, no NQA operations exist.
3. Specify the path jitter type and
enter its view.
type path-jitter
N/A
4. Specify the destination address
of ICMP echo requests.
destination ip
ip-address
By default, no
destination IP
address is specified.
5. (Optional.) Set the payload size
for each ICMP echo request.
data-size
size The default setting is 100 bytes.
6. (Optional.) Specify the payload
fill string for ICMP echo
requests.
data-fill
string
The default payload fill string is the
hexadecimal number
00010203040506070809.
7. Specify the source IP address
of ICMP echo requests.
source ip
ip-address
By default,
the packets take the
primary IP address of the output
interface as their source IP address.
The source IP address must be the
IP address of a local interface, and
the interface must be up. Otherwise,
no ICMP echo requests can be sent
out.
8. (Optional.) Set the number of
ICMP echo requests to be sent
in a path jitter operation.
probe packet-number
packet-number
The default setting is 10.
9. (Optional.) Set the interval for
sending ICMP echo requests.
probe packet-interval
interval
The default setting is 20
milliseconds.
10.
(Optional.) Specify how long
the NQA client waits for a
response from the server
before it regards the response
times out.
probe packet-timeout
timeout
The default setting is 3000
milliseconds.
11.
(Optional.) Specify an LSR
path.
lsr-path
ip-address&<1-8>
By default, no LSR path is specified.
The path jitter operation uses the
tracert to detect the LSR path to the
destination, and sends ICMP echo
requests to each hop on the LSR.
12.
(Optional.) Perform the path
jitter operation only on the
destination address.
target-only
By default, the path jitter operation is
performed on each hop on the path
to the destination.
Configuring optional parameters for the NQA operation
Unless otherwise specified, the following optional parameters apply to all types of NQA operations.
The parameter settings take effect only on the current operation.
To configure optional parameters for an NQA operation:

HPE FlexNetwork 5510 HI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5510 HI Series
Category	Switch
Language	English