56
5. Return to user view.
quit
N/A
6. Enable log output to the
monitor terminal.
terminal monitor
The default setting is enabled.
7. Enable the display of debug
information on the current
terminal.
terminal debugging
By default, the display of debug
information is disabled on the
current terminal.
8.
(Optional.) Set the lowest
level of logs that can be
output to the monitor
terminal.
terminal logging level
severity
(informational).
Outputting logs to a log host
1. Enter system view.
N/A
2.
center.
info-center enable
By default, the information center is
enabled.
3. Configure an output rule
for
log host.
info-center source
{ module-name |
default
}
{
console
|
monitor
|
logbuffer
|
logfile
|
loghost
} {
deny
|
level
severity }
For information about default output
rules, see "Default output rules for
logs."
4.
source IP address for
output logs.
info-center loghost source
interface-type interface-number
By default, the source IP address of
output log information is the primary
IP address of the matching route's
egress interface.
5.
the timestamp format.
info-center timestamp
loghost
{
date
|
iso
|
no-year-date
|
none
}
By default, the timestamp format is
date
.
6. Specify a log host and
configure related
parameters.
info-center loghost
[
vpn-instance
vpn-instance-name ] { loghost |
ipv4-address |
ipv6
ipv6-address }
[
port
port-number ] [
facility
local-number ]
By default, no
parameters are specified.
The value of the port-number
argument must be the same as the
value configured on the
log host.
Otherwise, the log host cannot
receive logs.
Outputting logs to the log buffer
1. Enter system view.
system-view
N/A
2.
center.
info-center enable
By default, the information center
is enabled.
3. Enable log output to the log
buffer.
info-center logbuffer
By default, log output to the log
buffer is enabled.
4. (Optional.) Set the maximum
number of logs that can be
stored in the log buffer.
info-center
logbuffer
size
buffersize
By default, the log buffer can store
512 logs.
To Next Page
Loading...
Need help?
General