HPE FlexNetwork 5510 HI Series Network Management And Monitoring Configuration Guide

254
<rpc-reply message-id="101" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<rpc-error>
<error-type>protocol</error-type>
<error-tag>lock-denied</error-tag>
<error-severity>error</error-severity>
<error-message xml:lang="en">Lock failed because the NETCONF lock is held by another
session.</error-message>
<error-info>
<session-id>1</session-id>
</error-info>
</rpc-error>
</rpc-reply>
The output shows that the lock operation failed because the client with session ID 1 held the lock,
and only the client holding the lock can release the lock.
Performing service operations
You can use NETCONF to perform service operations on the device, such as retrieving and
modifying the specified information. The basic operations include get, get-bulk, get-config,
get-bulk-config, and edit-config, which are used to retrieve all data, retrieve configuration data, and
edit the data of the specified module. For more information, see the NETCONF XML API reference
for the switch.
Performing the get/get-bulk operation
The get operation is used to retrieve device configuration and state information that match the
conditions. In some cases, this operation leads to inefficiency.
The get-bulk operation is used to retrieve a number of data entries starting from the data entry next to
the one with the specified index. One data entry contains a device configuration entry and a state
information entry. The data entry quantity is defined by the count attribute, and the index is specified
by the index attribute. The returned output does not include the index information. If you do not
specify the index attribute, the index value starts with 1 by default.
If either of the following conditions occurs, the get-bulk operation retrieves all the rest data entries
starting from the data entry next to the one with the specified index:
• You do not specify the count attribute.
• The number of matched data entries is less than the value of the count attribute.
# Copy the following text to the client to perform the get operation:
<?xml version="1.0" encoding="UTF-8"?>
<rpc message-id="100" xmlns="urn:ietf:params:xml:ns:netconf:base:1.0">
<getoperation>
<filter>
<top xmlns=" http://www.hp.com/netconf/data:1.0">
Specify the module, submodule, table name, and column name
</top>
</filter>
</getoperation>
</rpc>
Where, the <getoperation> parameter can be <get> or <get-bulk>. The <filter> element is used to
filter data, and it can contain module name, submodule name, table name, and column name.

HPE FlexNetwork 5510 HI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5510 HI Series
Category	Switch
Language	English