HPE FlexNetwork 5510 HI Series Network Management And Monitoring Configuration Guide

109
Step
Command
Remarks
1. Enter system view.
system-view
N/A
2. Create an NQA operation
and enter NQA operation
view.
nqa entry
admin-name
operation-tag
By default, no NQA operations exist.
3. Specify an NQA
operation type and enter
its view.
type
{
dhcp
|
dlsw
|
dns
|
ftp
|
http
|
icmp-echo
|
icmp-jitter
|
path-jitter
|
snmp
|
tcp
|
udp-echo
|
udp-jitter
|
udp-tracert
|
voice
}
N/A
4. Configure a description.
description
text By default, no description is configured.
5. Set the interval at which
the NQA operation
repeats.
frequency
interval
For a voice or path jitter operation, the
default setting is 60000 milliseconds.
For other types of operations, the default
setting is 0 milliseconds, and only one
operation is performed.
If the operation is not completed when the
interval expires, the next operation does
not start.
6. Specify the probe times.
probe count
times
By default:
• In
an UDP tracert operation, the
NQA client performs three probes to
each hop to the destination.
•
In other types of operations, the
NQA client performs one probe to
the destination per operation.
This command is not available for the
path jitter and voice operations. Each of
these operations performs only one
probe.
7. Set the probe timeout
time.
probe timeout
timeout
The default setting is 3000 milliseconds.
This
command is not available for the
ICMP jitter, path jitter, UDP jitter, or voice
operations.
8. S
et the maximum
number of hops that the
probe packets can
traverse.
ttl
value
The default setting is 30 for probe packets
of the UDP tracert operation, and is 20 for
probe packets of other types of
operations.
This
command is not available for the
DHCP or path jitter operation.
9. S
et the ToS value in the
IP header of probe
packets.
tos
value The default setting is 0.
10. Enable the routing table
bypass feature.
route-option bypass-route
By default, the routing table bypass
feature is disabled.
This
command is not available for the
DHCP and path jitter operations.
11. Specify the VPN instance
where the operation is
performed.
vpn-instance
vpn-instance-name
By default, the operation is performed on
the public network.

HPE FlexNetwork 5510 HI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5510 HI Series
Category	Switch
Language	English