327
• Configure the RADIUS server correctly to provide authentication and accounting functions for
users.
Configuring the portal server
This example assumes that the portal server runs on IMC PLAT 5.1 SP1 (E0202P05) and IMC UAM
5.1 (E0301).
1. Configure the portal server:
a. Log in to the IMC management platform and select the Service tab.
b. Select User Access Manager > Portal Service Management > Server from the
navigation tree to enter the portal server configuration page, as shown in Figure 106.
c. Config
ure the portal server heartbeat interval and user heartbeat interval.
d. Use default values for other parameters.
e. Click OK.
Figure 106 Portal server configuration
2. Configure the IP address group:
a. Select User Access Manager > Portal Service Management > IP Group from the
navigation tree to enter the portal IP address group configuration page.
b. Click Add to enter the page shown in Figure 107.
c. Enter the IP group n
ame.
d. Enter the start IP address and end IP address of the IP group.
Make sure that the host IP address is in the IP group.
e. Select a service group.
By default, the group Ungrouped is used.
f. Select the IP group type Normal.
g. Click OK.
To Next Page
Loading...
Need help?
General
