242
Controller no connection error. Communications cannot be established or an unsupported controller is connected.
The probable causes are as follows:
① It is a communication failure due to a break in or noise from the communication line.
② The communication baud rate of the controller is not supported by the teaching pendant.
(The failure may be resolved by the controller power reconnection.)
③ The model not supported by the teaching pendant is connected. (Refer to Support Models.)
The EMERGENCY STOP button of the teaching pendant is pressed.
Non-supported controller is connected.
CTL Not Connected
Emergency Stop
Non-supported CTL is connected
DEE
DEF
DF0
To Next Page
Loading...
