Note: If the drive is the FRU that is isolated by the diagnostics,
check that the connectors are properly seated. If the drive
has recently been replaced because of a similar problem,
contact your service personnel.
YES The problem is fixed.
This completes the MAPs for the IBM Power System with AIX Operating System.
Step 17 (IBM Power System with IBM i Operating System Only)
You are here because the host system is an IBM Power System with IBM i
Operating System or iSeries host system. This step verifies that the installed
devices are properly configured to the host system.
1. At the command line on the Main Menu, type
wrkcfgsts
then press Enter. The Work with Configuration Status display appears.
2. In the Type field, type
*dev
3. In the Configuration Description field, type
*tap
then press Enter twice.
Does the device that you are configuring appear under the Description column,
and can you vary it on and off successfully?
Note: To determine the number of the device that you are configuring, see
"Performing the Checkout Procedure," in Chapter 3, “Attaching the 7226
Storage Enclosure to a Host System,” on page 31
NO Continue with Step 18 (IBM Power System with IBM i Operating System
Only).
YES Go to Step 19 (IBM Power System with IBM i Operating System Only).
Step 18 (IBM Power System with IBM i Operating System Only)
This step verifies whether the installed devices can communicate with the IBM
Power System with IBM i Operating System.
1. At the command line on any IBM i menu, type
strsst
then press Enter.
2. At the System Service Tools (SST) screen, type 1 (Start a service tool), then
press Enter.
3. At the Start a Service Tool screen, type 7 (Hardware service manager), then
press Enter.
4. At the Hardware Service Manager screen, type 2 (Logical hardware resources),
then press Enter.
5. At the Logical Hardware Resources screen, type 1 (System bus resources), then
press Enter.
Chapter 10. Troubleshooting 131
To Next Page
Loading...
Need help?
General
