To Next Page

To Previous Page

Replacing a DVD Drive Feature

1. Prepare the 7226 Storage Enclosure for Service. See “Preparing the 7226 Storage

Enclosure for Removal or Installation of a Storage Device or Other Component”

on page 138 for the correct procedure.

Note: The 7226 Storage Enclosure does not need to be extended from the rack

for this procedure.

2. Determine which DVD Drive will be replaced.

3. Remove the DVD Drive. Push the latch 1 up toward the drive and begin to

pull the drive out of the Slim Tray. Grasp the DVD Drive 2 and slide it out of

the enclosure.

4. Locate the new DVD Drive Feature.

ROLSOS833-0

Figure 74. Removing a DVD

Chapter 11. Installation and Removal Procedures 153

Other manuals for IBM 7226

Questions and Answers:

Need help?

Do you have a question about the IBM 7226 and is the answer not in the manual?

General