Preparing the 7226 Storage Enclosure for Removal or Installation of a
Storage Device or Other Component
Use the following procedure to prepare the 7226 Storage Enclosure for removal or
installation of a storage device or other component.
Note: Before performing this procedure, ensure that there is no activity between
the host system and the installed devices or operations being performed by
the installed devices. Turning off the 7226 Storage Enclosure power during
activity could result in loss of data.
1. Remove any media from the installed devices.
Note: Device means either drive or bay blank.
2. Turn off the power to the 7226 Storage Enclosure.
3. Remove the 7226 Storage Enclosure from the host system configuration (for
instructions, refer to your system manuals).
4. Unplug the 7226 Storage Enclosure power cable from the electrical outlet.
The 7226 Storage Enclosure is now prepared for removal or installation of a storage
device or other component. Refer to the appropriate procedure in this chapter.
138 7226 Storage Device Enclosure Setup, Operator and Service Guide
To Next Page
Loading...
Need help?
General
