To Next Page

To Previous Page

Manually Removing a DVD Disc from the Drive

If a power failure or a DVD-RAM drive failure prevents the DVD disc tray from

ejecting, the disc can be removed manually.

To manually remove the DVD disc:

1. Turn off the power to the 7226 Storage Enclosure.

2. Insert the straightened end of a paper clip into the emergency eject hole until

you feel some resistance.

3. Continue to push in the paper clip while you pull out the tray with your

fingernail.

4. Pull the tray completely open and remove the disc. It is usual for the tray to

make a clicking sound while you are pulling it open.

192 7226 Storage Device Enclosure Setup, Operator and Service Guide

Other manuals for IBM 7226

Questions and Answers:

Need help?

Do you have a question about the IBM 7226 and is the answer not in the manual?

General