To Next Page

To Previous Page

Replacing a Tape Drive Feature or a Removable Disk Drive Feature

1. Prepare the 7226 Storage Enclosure for Service. See “Preparing the 7226 Storage

Enclosure for Removal or Installation of a Storage Device or Other Component”

on page 138 for the correct procedure.

Note: The 7226 Storage Enclosure does not need to be extended from the rack

for this procedure.

2. Determine the location for the Drive Feature to be replaced.

3. To remove the drive, push the drive latch 1 toward the drive and begin to

pull the drive out of the enclosure. Grasp the drive 2 and pull the assembly

out of the drive bay. Disconnect the cables 3 from the drive assembly.

4. Place the drive assembly on an ESD protected work surface.

5. Locate the new Drive Feature.

ROLSOS831a-0

Figure 72. Removing a Drive

Chapter 11. Installation and Removal Procedures 151

Other manuals for IBM 7226

Questions and Answers:

Need help?

Do you have a question about the IBM 7226 and is the answer not in the manual?

General