3. Pull out the cable-management arm pin 1, and then slide that cable
management arm tab out of the slot 2 on the outside of the slide rail. Pull
out the other cable-management arm pin 3, and then slide the
cable-management arm tab 4 out of the slot on the inside of the slide rail. Lift
the cable-management arm off the support arm.
4. Pull out the mounting bracket pin 1 and slide the mounting bracket 2 out
of the slide.
ROLSOS815-0
Figure 20. Slide rail and movable tab
ROLSOS816-0
Figure 21. Cable Management Arm
Chapter 2. Installing the 7226 Storage Enclosure into a Rack 25
To Next Page
Loading...
