– Reset Enhanced Global Mirror Group statistics
– Reset iSCSI IP address
– Resume Enhanced Global Mirror Group
– Resume Performance Read Cache
– Revive Array
– Set Enhanced Global Mirror Group
– Show Enhanced Global Mirror Group synchronization progress
– Show Cache Memory Diagnostic Status
– Show array export dependenciesy
– Start Cache Backup Device Diagnostic
– Start Storage Subsystem Configuration Database Diagnostic
– Stop Performance Read Cache performance modeling
– Suspend Enhanced Global Mirror Group
– Test Enhanced Global Mirror Group connectivity
– Test Enhanced Global Mirror Group connectivity
v Commands deprecated in this release:
– start rollback (volume
– [flashcopyVolumeName | volumes
– [flashcopyVolumeName1 ...
– flashcopyVolumeNamen])
What's new in the DS Storage Manager V10.83 with controller firmware version
7.83.xx.xx release
This guide contains information about enhancements to the IBM DS Storage Manager version 10.83.xx
with controller firmware version 7.83.xx.xx release:
v Enhanced FlashCopy: For details, see Chapter 6, “Using the Enhanced FlashCopy Images Premium
Feature,” on page 6-1.
v Disk pools: For details, see “Disk Pools” on page 4-10.
v Commands introduced in this release:
– “Disk Pool Commands” on page 3-325
– “Enhanced FlashCopy Commands” on page 3-327
– “Repository Logical Drive Analysis Commands” on page 3-331
– “Support Bundle Collection Commands” on page 3-335
v Commands updated in this release:
– Activate Enhanced Remote Mirroring Feature
– Activate iSCSI Initiator
– Auto-configure Storage Subsystem
– Check logicalDrive Parity
– Check Remote Mirror Status
– Clear logicalDrive Reservations
– Clear logicalDrive Unreadable Sectors
– Clear Storage Subsystem Firmware Pending Area
– Create subsystem
– Create FlashCopy logicalDrive
– Create Host
xiv IBM System Storage DS3000, DS4000, and DS5000: Command Line Interface and Script Commands Programming Guide
To Next Page
Loading...
Need help?
General