– Create Host Group
– Create Host Port
– Create iSCSI Initiator
– Create RAID logicalDrive (Automatic Drive Select)
– Create RAID logicalDrive (Free Extent Based Select)
– Create RAID logicalDrive (Manual Drive Select)
– Create Remote Mirror
– Create Storage Subsystem Security Key
– Create VolumeCopy
– Delete subsystem
– Disable Storage Subsystem Feature
– Download Enclosure Configuration Settings
– Download Enclosure Environmental Card Firmware
– Export Storage Subsystem Security Key
– Load Storage Subsystem DBM Database
– Recopy VolumeCopy
– Remove VolumeCopy
– Reset Controller
– Reset Storage Subsystem Battery Install Date
– Reset Storage Subsystem Diagnostic Data
– Reset Storage Subsystem SAS PHY Baseline
– Revive subsystem
– Revive Drive
– Save Controller NVSRAM
– Save Drive Channel Fault Isolation Diagnostic Status
– Save Drive Log
– Save Storage Subsystem RLS Counts
– Save Storage Subsystem SOC Counts
– Save Storage Subsystem Support Data
– Set subsystem Forced State
– Set Controller
– Set Controller Service Action Allowed Indicator
– Set Drive Hot Spare
– Set Drive State
– Set Enclosure Identification
– Set Enclosure Service Action Allowed Indicator
– Set Foreign Drive to Native
– Set Host
– Set Host Group
– Set Host Port
– Set iSCSI Initiator
– Set iSCSI Target Properties
– Set Session
– Set Storage Subsystem
– Set Storage Subsystem Enclosure Positions
About this document xv
To Next Page
Loading...
