NL-Port ID: 0x010300
Maximum data rate: 8 Gbps
Current data rate: 4 Gbps
Data rate control: Auto
Link status: Up
Topology: Fabric Attach
World-wide port identifier: 20:6f:00:a0:b8:29:ed:8a
World-wide node identifier: 20:0e:00:a0:b8:29:ed:8a
Part type: PM8032 revision 5
Host interface: Fibre
Channel: 7
Current ID: Not applicable/0xFFFFFFFF
Preferred ID: 14/0xD1
NL-Port ID: 0xFFFFFF
Maximum data rate: 8 Gbps
Current data rate: 8 Gbps
Data rate control: Auto
Link status: Down
Topology: Not Available
World-wide port identifier: 20:7f:00:a0:b8:29:ed:8a
World-wide node identifier: 20:0e:00:a0:b8:29:ed:8a
Part type: PM8032 revision 5
Host interface: Fibre
Channel: 8
Current ID: Not applicable/0xFFFFFFFF
Preferred ID: 15/0xCE
NL-Port ID: 0xFFFFFF
Maximum data rate: 8 Gbps
Current data rate: 8 Gbps
Data rate control: Auto
Link status: Down
Topology: Not Available
World-wide port identifier: 20:8f:00:a0:b8:29:ed:8a
World-wide node identifier: 20:0e:00:a0:b8:29:ed:8a
Part type: PM8032 revision 5
The summary information is also returned as the first section of information when you use the profile
parameter.
The show commands return information about the specific components of a storage subsystem. The
information returned by each of the show commands is the same as the information returned by the show
storageSubsystem profile command, but the information is constrained to the specific component. For
information about a command, refer to the page number shown.
v “Show Controller” on page 3-253
v “Show Disk Drive” on page 3-256
v “Show Drive Channel Statistics” on page 3-258
v “Show Storage Subsystem Host Topology” on page 3-277
v “Show Storage Subsystem LUN Mappings” on page 3-277
v “Show Logical Drive” on page 3-264
v “Show subsystem” on page 3-247
v “Show Logical Drive Reservations” on page 3-269
In addition, these commands return information about a storage subsystem:
v “Show Controller” on page 3-253
v “Show Enhanced Remote Mirroring Logical Drive Candidates” on page 3-262
v “Show Storage Subsystem Auto Configure” on page 3-272
Chapter 4. Configuring a Storage Subsystem 4-31
To Next Page
Loading...
Need help?
General