Table 2-4. Recurring Syntax Elements (continued)
Recurring Syntax Syntax Value
ethernet-port-options
enableIPv4=(TRUE | FALSE) | enableIPv6=(TRUE
| FALSE) |IPv6LocalAddress=ipv6-address |
IPv6RoutableAddress=ipv6-address |
IPv6RouterAddress=ipv6-address |
IPv4Address=ip-address |
IPv4ConfigurationMethod=(static | dhcp) |
IPv4GatewayIP=ip-address |
IPv4SubnetMask=ip-address | duplexMode=(TRUE
| FALSE) | portSpeed=(autoNegotiate | 10 |
100 | 1000)
iscsi-host-port-options
IPv4Address=ip-address |
IPv6LocalAddress=ipv6-address |
IPv6RoutableAddress=ipv6-address |
IPv6RouterAddress=ipv6-address | enableIPv4=
(TRUE | FALSE) | enableIPv6= (TRUE | FALSE)
| enableIPv4Priority= (TRUE | FALSE) |
enableIPv6Priority= (TRUE | FALSE) |
IPv4ConfigurationMethod= (static | dhcp) |
IPv6ConfigurationMethod= (static | auto) |
IPv4GatewayIP=ip-address |
IPv6HopLimit=integer |
IPv6NdDetectDuplicateAddress=integer |
IPv6NdReachableTime=time-interval |
IPv6NdRetransmitTime=time-interval |
IPv6NdTimeOut=time-interval |
IPv4Priority=integer | IPv6Priority=integer
| IPv4SubnetMask=ip-address |
IPv4VlanId=integer | IPv6VlanId=integer |
maxFramePayload=integer |
tcpListeningPort=tcp-port-id |
portSpeed=(autoNegotiate|1|10)
test-devices-list
controller=(a | b) |
esms=(esm-speclist) |
drives=(drive-spec-list)
test-devices
controller=(a | b)esms=(esm-spec-
list)drives=(drive-spec-list)
flashcopy-schedule-attribute-value-
list
flashcopy-schedule-attribute-valuepair
{flashcopy-schedule-attribute-valuepair}
time-zone-spec
(GMT+HH:MM | GMTHH:MM)
[dayLightSaving=HH:MM]
flashcopy-schedule-attribute-value-
pair
startDate=MM:DD:YY
scheduleDay=(dayOfWeek|all)startTime=HH:MM
scheduleInterval=integer
endDate=(MM:DD:YY|noEndDate)
timesPerDay=integer
1
For enclosure loss protection to work, each disk drive in an subsystem must be in a separate enclosure.
If you set the enclosureLossProtect parameter to TRUE and you have selected more than one disk drive
Chapter 2. About the Script Commands 2-9
To Next Page
Loading...
