53
ifm Vision Assistant O3M
UK
7.1.7 Online parameter setting
With the [Online parameterisation] switch, the online parameter setting of the device is activated.
When "online parameterisation" is activated, changed parameters will be immediately written to the
device. The changes are visible within a very short time (real-time).
The changes are written in a volatile partition of the RAM and are lost e.g. when the device is
rebooted.
► Save the changes permanently by clicking on
[Save].
If "online parameterisation" is deactivated, changed parameters are only written after clicking on
[Save]. The changes are stored in a non volatile partition of the RAM and will be visible after approx. 15
seconds.
"Online parameterisation" is deactivated by default.
"Online parameterisation" can be used by controllers (CAN controllers). Adequate libraries are
available for ifm mobile controllers with CAN input
(→ „16.3 Connect O3M to external devices“).
To Next Page
Loading...
