IFM O3M150 - System Requirements; Software; Hardware and Accessories

7
ifm Vision Assistant O3M
UK
2 System requirements
2.1 Software
The following software versions are required for operation:
● Operating system: Windows 7 (32/64 bits), Windows 8.1 (32/64 bits), Windows 10 (32/64 bits)
● Application software: ifm Vision Assistant 1.8.9.0
● Firmware DI: 4.21.x
● Firmware OD: 4.21.x
● Firmware LG: 4.21.x
The required software can be found at
www.ifm.com
.
Other versions of the ifm Vision Assistant may contain changed or new functions which are not
described in this software manual.
2.2 Hardware and accessories
The following hardware is required for operation:
● Sensor of the O3M family
● PC with x86 or x64 type processor
● Screen: min. 1024 x 768 pixels, 32-bit colour depth
The following accessories are required for operation:
● Cable for network connection (Ethernet) for parameter setting, M12 connector/RJ45 connector, 4
poles, e.g. article no. E11898 (2 m), E12283 (5 m)
● Illumination unit
● Article no. O3M950 for O3M15x and O3M25x
● Article no. O3M960 for O3M16x and O3M26x
● MCI connection cable between sensor and illumination unit, article no. E3M121, E3M122 or E3M123
● Power supply cable for the illumination unit, article no. E3M131, E3M132 or E3M133
● Sensor cable for CAN bus and power supply, article no. E11596, E11597 or
EVC492 (EVC492 incl. terminating resistor)
● CAN USB interface "CANfox", article no. EC2112
● CANfox adapter cable, article no. EC2114
● Power supply 24 V, minimum 2.4 A, e.g. article no. DN4012
You will find further information about available accessories at
www.ifm.com
.