Intermec CK30

XX
/
YY
Using the Terminal Emulation MenusChapter —4
94 TE 2000
 5250 Terminal Emulation Programmer’s Guide
Display Positions 4 through 6
Low battery condition (17XX, 11XX)
A Low Battery indication is v er y important to the operation of the termi-
nal, letting you know that your terminal will stop operating shortly. Your
terminal should continue to operate 30 minutes to 2 hours depending on
how you use it. Data stored in RAM is saved for approximately 30 days.
However, you should avoid testing this limit.
Your terminal does retain its RAM data storage for up to 5 minutes with
the battery pack removed. It is always a good idea to replace the battery
pack with a fresh recharged pack immediately after removing the dis-
charged pack. Without battery power, your terminal does not operate, and
your display will be blank.
Display Positions 4 through 8
Current Row/Column Position (59XX)
Shows the current location of the cursor, with “XX” as the row position
and “YY” as the column position. For example, if the cursor is at row 5,
column 12, the annunciators will show “05/12” in positions 4–8.
Display Positions 5 through 8
Battery Pack Gas Gauge Icons (6400)
These battery icons represent the charge level in your main battery pack.
Four icons (positions 5–8) indicates more than 76% charge level
Three icons (positions 5, 6, and 7) indicates between 51–75%
Two icons (positions 5 and 6) indicates between 26–50%
One icon (position 5) indicates betw een 21–25%
When the terminal gets below 20%, the icons are replaced by Ls and after
the charge level is less than 10% your terminal emits a series of beeps.
Four Ls indicates 16–20% ch arge level
Three Ls indicates 11–15%. At the 15% ch arge level, your te rminal beeps once. The
sound duration and frequency are at levels you have set for your terminal.
Two Ls indicates 6–10%. At the 10% and 7% c harge levels, your terminal beeps once.
The sound duration and frequency are at levels you have set for your terminal.
One L indicates 0–5%. At this ch arg e level, your terminal beeps thre e time s at its cur-
rent setting level for both duration and frequency.
Note: If you have the beeper turned off, you will not hear any of the low
battery beep warnings.
The battery pack icons on your terminal display reflect the same status as
theLEDsonthebatterypack.However,theremaybeaoneminutedelay
for updating the icons on the display when the battery pack is replaced.
+
--