Intermec CK30

Using the Terminal Emulation Menus—Chapter 4
121TE 2000
 5250 Terminal Emulation Programmer’s Guide
After all of the length options are set for the enabled bar code, the display
returns to either the Scan Options menu or the Scan Options 2 menu
(pending on from which menu the bar code was enabled).
(bar code type)
Max Length xx
(bar code type)
Max Length xx
Min Length xx
(bar code type)
Max Length xx
Min Length xx
Fix Length 1 xx
Fix Length 2 xx
Fix Length 3 xx
(bar code type)
Drop Leading xx
(bar code type)
Drop Leading xx
Drop Trailing xx
(bar code type)
Max Length xx
Min Length xx
Fix Length 1 xx
(bar code type)
Max Length xx
Min Length xx
Fix Length 1 xx
Fix Length 2 xx
(bar code type)
Max Length xx
Min Length xx
Fix Length 1 xx
Fix Length 2 xx
Fix Length 3 xx
Fix Length 4 xx
3) Protocol Opts
Use the 3) Protocol Opts menu to designate the type of terminal emula-
tion the host supports. You can also use it to designate additional com-
mands and command sets.
Protocol Opts
1) Host View Sze
2) Data Stream
3) Extended Cmds
4) 5250
5) 3270
6) VT/ANSI
7) Native
7) Native is blank if UDP Plus
or TCP/IP