Intermec CK30

Getting Started—Chapter 1
3TE 2000
 5250 Terminal Emulation Programmer’s Guide
Starting the TE 2000 Application
You are ready to start your application once the terminal is set up, the ter-
minal and the network are configured, and communications are estab-
lished with the gateway and access point or host.
To start your application:
Turn on the terminal. Wait a few seconds while the initialization screens
(below) clear and the application starts.
COPR. 1991-2005
INTERMEC. ALL
RIGHTS RESERVED
V<version number>
<release date>
<program name> <version>
Host: <host name>
<emulation type>
TE 2000(TM)
<program name> <version>
<emulation type>
Host: <host name>
For Version 7.26 or greater
<program name> <version>
Session: <current session number>
<session name>
<emulation type>
Host: <host name>
<device name>
For Version 8.00 or greater
Note: If your application does not start after a few seconds, you may not
have configured the terminal correctly. For help, refer to your terminal’s
user manual.
You can now do one of the following:
S Become familiar with TE 2000 5250 if you have not previously used it.
S Perform a quick configuration.
S Configure your TE 2000 application.
S Customize your TE 2000 application.
Becoming Familiar With the TE 2000 5250 Application
If you have not previously used the TE 2000 5250 application, see Chap-
ter 2, “Using Terminal Emulation Applications,” to understand 5250 com-
mands. See Chapter 3, “Using the Terminal’s Keyboard,” to become familiar
with your terminal’s keyboard and the keys you need to press to perform
5250 commands.