Customizing Your ConfigurationChapter —5
256 TE 2000
5250 Terminal Emulation Programmer’s Guide
Appending Data Files To Intel-Hex Files
In the above example, you could have bound the .EXE files together by
typing the following (single) command line:
flshconv -f8000 -effc0 -d60 1700bios.exe kernel.exe
fwp170h0.exe -o1700exe s.hex
You can then customize the 1700EXES.HEX file with diffe rent font files
and literal files by typing the following (single) command line:
flshconv -effc0 -a 1700exes.hex norand.fntcfglit.dat
–onewlang.hex
You can provide keyboard translation file pairs to change the default key
values. The (single) command line is:
flshconv -effc0 -a newlang.hex vt220eml.key vt220eml.xlt
-onewkeys.hex
You can specify more than one file pair. For example, you could provide
all four file pairs (eight files) to modify the keyboard for each of the four
data streams.
Downloading a Hex File
Use these to download a . HEX file to 59XX, 17XX, 11XX Terminals:
S PROGDUX.EXE (provided with the terminal’s F lash)
S Personal computer
S INTERMEC
r
cable P/N: 216-806-001, which is a powered Flash cable
that plugs into the personal computer’s COM port (note that power is
not required for download)
To download a .HEX file:
1 Ensure the terminal is powered ON and PROGDUX.EXE is loaded on
the personal computer.
2 Use cable P/N: 216-806-001 to connect the 11XX or 17XX Terminal
to the PC. Use cable P/N: 216-831-001 to connect the 59XX Terminal
to the personal computer. Power the terminal off. For help, refer to the
terminal’s user manual. Power is not required for download.
3 To receiv e the .HEX file, the terminal must be in download mode. To
enter this mode, press and hold down the terminal’s [I] key as you pow-
er up the terminal. For the 17XX 37-key keyboard, press and hold
down the [F1] key as you power up the terminal.
4 At the DOS prompt, type:
progdux -?
to display a list of command
line options.
5 Erase the terminal’s original Flash and download the new .HEX file by
typing:
progdux -e <newfile>
where <newfile> isthenameofthe
.HEX file.
A successful download will boot the terminal into the TE application. If
communications is interrupted, PROGDUX.EXE will send out a negative
acknowledgement (NAK) and r eset itself to try sending again. No interac-
tion is required except to restore communications.
To Next Page
Loading...
