Intermec CK30

Using the Terminal Emulation MenusChapter —4
164 TE 2000
 5250 Terminal Emulation Programmer’s Guide
4) Tests
Intermec Systems Engineers use the 4) Tests menus to verify terminal op-
eration during environmental stress tests, peripherals, the display, RF com-
munications, and memory.
Tests
1) Peripherals
2) Converters
3) Memory View
4) Packet Driver
5) Numbers
6) Timed Numbers
3) Memory View and
4) Packet Driver
are for 6400, 5055, 59XX, 17XX,
11XX
2) Converters is for 59XX
5) Numbers and
6) Timed Numbers
are blank for 700 Series, CK30,
CK31, CV60
1) Peripherals
1) Peripherals tests terminal peripheral devices, such as radio, RS-232, dis-
play, keyboard, and scanner. Detailed descriptions of each peripheral test
follows.
Peripherals
1) Radio Test
2) RS232 Test
3) Display Test
4) Keyboard Test
5) Scanner Test
1) Radio Test is for
6400, 5055
802.11 (Lucent) radios
2) RS232 Test,
3) Display Test, and
4) Keyboard Test are for
6400, 5055, 59XX, 17XX, 11XX
1) Radio Test (802.11 (Lucent) Radios — 6400, 5055)
Several factors influence the rate at which a frame is transmitted. First, the
radio’s transmission rate is configured in the net.cfg file. The keyword
Transmit_Rate in net.cfg holds a numeric value for the transmission rate.
The transmission rate is also affected by the characteristics of the RF link.
If the radio encounters problems sending a higher transmission rate be-
cause the RF link is weak, busy, or noisy, the r adio may retry the transmis-
sion at a lower data rate. Thus, the TxRate reported may be lower than the
configured transmission rate. Only the transmission rate of the most recent
and successful transmission is reported.
Transmit_Rate values and their respective supported transmission rates
available in the high speed Lucent radios are as follows:
1 Fixed Low (1 Mb/s) 5 Fixed High (11 Mb/s)
2 FixedStandard(2Mb/s) 4 ARSStandard(2Mb/s)
3 ARS High (11 Mb/s default) 4 ARS Medium (5.5 Mb/s)
4 Fixed Medium (5.5 Mb/s)