Intermec CK30

299TE 2000  5250 Terminal Emulation Programmer’s Guide
Extended Commands
7
Extended commands govern abilities unique to terminals. You can use ex-
tended commands to transmit or r eceive data over the terminal’s RS-232
port, send information to an RS-232 device (such as a printer or bar code
printer), or collect data. The following chart lists the commands.
Name Characters
Transmit and Rec eive On RS-232 Port #F
Transmit Only On RS-232 Port #P
Receive Only On RS-232 Port #G
Set Paramete rs (supported on 6400, 5055, 59XX, 17XX, 11XX) #H
Return Version #V
Tone #T
Scan #S
Get Optical Inputs (supported on 248X) #I
Read,Set,andResetRelayCommands(supported on 248X) #R
Magnetic Card Reader (supported on 700 Series) #M
To use extended commands, you must enable the extended command op-
tion through the TE configuration menus. See Chapter 4, “Using the Ter-
minal Emulation Menus,” for information about enabling the command on
aterminal.