Extended Commands—Chapter 7
307TE 2000
5250 Terminal Emulation Programmer’s Guide
Thefollowingtabledescribesthelineandcolumnswherecharactersmust
appear, and their meanings. Note that the line and column information
refers to a 3278 unit with a 24-line by 80-column display and that “b”in-
dicates a 1-byte space. The display buffer position refers to the same buffer
but with a linear array ranging from 0–1919.
Transmit Only Characters — Line 1, Columns 2–12
Column Description Character
2 Extended command #
3 Transmit Only On RS-232 Port command P
4 S peed (bits per se cond) 1=1200; 2=2400; 3=4800; 4=9600; 5=19200;
6=38400
5 Data parity N=None; 0 (zero)=None; b=None; E=Even; O=Odd
6 Data bits 7=S even; 8=Eight
7 Stop bits 1=One; 2=Two
8 For 6400, 5055, 59XX, 17XX, 11XX:
CTS flow control
For 2 415, 2425, 2435A, 2455, 2475, 248X, 5020,
700 Series: Reserved
0=Disable; 1=Enable
9 For 6400, 5055, 59XX, 17XX, 11XX:
DTR flow control
For 2 415, 2425, 2435A, 2455, 2475, 248X, 5020,
700 Series: Reserved
0=Disable; 1=Enable
10 XON/XOFF flow control 0=Disable; 1=Enable
11-12 Flow control timeout value XX=Nu mber of seconds
13 Retu rn AID key b=AID key is Enter (default). X=AID key character.
See the “Return AID Keys” table on page 303 for
characters.
Flow Control
Transmit Only supports RTS/CTS, DTR/DSR, and XON/XOFF. For
descriptions, see page 302.
To Next Page
Loading...
