Intermec CK30

Bar Code SymbologiesAppendix —B
366
TE 2000
 5250 Terminal Emulation Programmer’s Guide
Bar C ode Algorithms
You can enable specific bar code algorithms using the setup menus or the
host computer. Once the computer correctly decodes a bar code, the com-
puter encodes data with descriptive information about the symbol. Re-
sponse time is improved by limiting the computer to bar codes being used.
Bar Code Data String Formats
Bar Code
Type Character
Symbology Type Data Format Data Length
“0” UPC short (UPC-E) nddddddc 8
“1” EAN short (EAN-8) fndddddc 8
“2” UPC long (UPC-A) nddddddddddc 12
“3” EAN long (EAN -13) fnddddddddddc 13
“4” UPC short add-on 2 nddddddcaa 10
“5” EAN short add-on 2 fndddddcaa 10
“6” UPC long add-on 2 nddddddddddcaa 14
“7” EAN long add -on 2 fnddddddddddcaa 15
“8” UPC short add-on 5 nddddddcaaaaa 13
“9” EAN short add-on 5 fndddddcaaaaa 13
“:” (colon) UPC long add-on 5 nddddddddddcaaaaa 17
“;” (se micolon) EAN long add-on 5 fnddddddddddcaaaaa 18
“<” (less than) Interleaved 2 of 5 d......d Scan device dependent
“=” (equal sign) Standard 2 of 5 d......d Scan device dependent
“>” (greate r than) Plessey d......dc Scan device dependent
“@” (ampersand) Codabar sd....ds Scan device dependent
“S” Code 11 d......d Scan device dependent
“P” Code 39 d......d Scan device dependent
“Q” Extended Code 39 d......d Scan device dependent
“R” Code 93 d......d Scan device dependent
“J” Code 128 d......d Scan device dependent
Note: These bar code data definitions apply to the Data Format column in
the previous table:
a Add-on code digits
cCheckdigits
d Bar code digits
fEANflag1characters
n Number system digits
s Start and stop digits
If M OD 10 or MOD 11 check digits are enabled, the digit f alls at the end
of a bar code data string. Each check digit enabled extends the bar code
data string length by one character.