Intermec CK30

Using the Terminal Emulation MenusChapter —4
98 TE 2000
 5250 Terminal Emulation Programmer’s Guide
Configuring TE Parameters
This chapter contains the TE configuration menus f or the following termi-
nals: 2415, 2425, 2435A, 2455, 2475, 248X, 6400, 5020, 5055, 59XX,
17XX, 11XX, 700 Series, CK30, CK31, and CV60 unless otherwise no-
ted. Additional information is available for each of the following:
S Trakker Antares (2415, 2425, 2435A, 2455, 2475, 248X) page 177
S 6400 Computer page 177
S 5055 Data Collection PC page 178
Note: Screens are shown with all of the available options.
S If an option is not assigned to a specific terminal, then that option is
available for all of the terminals addressed in this publication.
S If an option is specific towards a terminal, this option does not appear
on the display, or will be blank, for all other terminals.
KeySequencetoOpenMainMenu
To configure TE parameters on your respective terminal, at the initializa-
tion screens or anywhere in a TE session, access the Main Menu by press-
ing the following key sequence:
Terminal Key Sequence
2415
)! (55-key keyboard)
(5 (37-key keyboard)
2425
(!
2435A
rl (57-key keyboard)
Green >,Orange> (48-key keyboard)
rl (39-ke y function numeric keyboard)
2455, 2475, 248X
(¡
6400 [Gold] [Blue]
5020
CA
5055 [Blue] [M] or [ALT] [M]
59XX [Brown] [Black]
17XX, 11XX [Gold] [Black]
700 Tap twice on the upper-right corner of the display; or
via the Software Input Panel (SIP) keyboard, tap
SG .
CK30
[Alt] [M] (52-key keyboard)
C [Ctl] [M] (50-key keyboard)
[Alt]
B [F3] (42-key keyboard)
CK31 Tap twice on the upper-right corner of the display; or via the
external keyboard, press [Alt] [M].
CV60 Tap twice on the upper-right corner of the display; or via the
external keyboard, press [Alt] [M].