Intermec CK30

Extended CommandsChapter —7
304 TE 2000
 5250 Terminal Emulation Programmer’s Guide
Return Codes for Transmit and Receive
Line 24, Column 1, has the return status field. The code returned in this
position tells the host the extended command status. The codes are listed
in this chart.
Code Description Column
0 Good status, transaction complete. (None)
1 Not enough memory. Or, inc orrec t setting for speed, number of data bits or stop bits, or
flow control timeout.
4, 6, 7, 11–12
2 No delimiter (#) on data stream. (None)
3 Timeout while using CTS flow control (6400, 5055, 59XX, 17XX, 11XX). (None)
4 Timeout while using DTR flow control (6400, 5055, 59XX, 17XX, 11XX).(None)
5 Timeout while using XON/XOFF flow control. (None)
6 Improper return field. (None)
7 Hexadecimal value is outside the range of 00–0F. 15–16, 19–20
8 Error in AID code. (None)
9 Incorrect se tting for maximum characters to re ce ive. 13–14
A Incorrect s etting for delimiter character. 15–16
B Incorrect setting for number of delimiter characters. 17–18
C Incorrect setting for CTS, DS R, or XON/OFF flow control. 8, 9, 10
D Incorrect setting for start characte r. 19–20
E Incorrect se tting for data parity. 5, 22
f/F* Timeout. (None)
o/O* Overrun of UART receive register; an error from the RS-232 device. (None)
p/P* Data parity or framing error. (None)
R Syntax error from RD5500 Remote Display (not the expected ch aracter; no character error
was detected). (Applies only to the 17XX Terminal.)
(None)
* An uppercase letter indicates an error from the RS-232 device. A lowercase letter indicates an error from the
RD5500 Re mote Display (applies only to the 17XX T erminal).