Intermec CK30

Customizing Your ConfigurationChapter —5
188 TE 2000
 5250 Terminal Emulation Programmer’s Guide
Follow these procedures to disable (or delete) the auto-login script file.
The method depends on the type of terminal you are using.
2415, 2425, 2435A, 2455, 2475, 248X Terminals
1 Press the appropriate key sequence or scan the following bar code to ac-
cess the TRAKKER Antares
R
2400 Me nu System’s Main Menu:
Enter Test and Service Mode
*../M.*
*..-.*
2 Choose System Menu and then choose File Manager.
3 Select drive C. Press Y or B to highlight AUTOLOG.SCR.
4 Press [FnL .] to delete the file or press [F7] to rename the file.
5 Exit the TRAK KER Antares 2400 Menu System to r eturn to your cur-
rent TE session. Restart the TE application to use TE without the auto-
login.
You can also rename the auto-login script file from your host. For help,
refertoyourterminal’susermanual.
5020, 700 Series, CK30, CK31, CV60 Terminals
Via your web browser, access the IP address at http://<IP address>,double-
click the File Manager desktop icon, select File,thenpressthe[Del] key
to remove the auto-login feature.
For the terminal, using Microsoft ActiveSync, browse for the auto-login
file, right-click the file for a pop-up menu, then select Delete to remove
thefilefromtheterminal.
6400, 5055 Terminals
1 Reboot the terminal to a DOS prompt.
S For the 6400 Computer:
press and hold the yellow, blue, and both green enter keys until the
terminal resets. Watch the screen as the terminal boots and press 0
(zero) when the prompt appears.
S For the 5055 Data Collection PC:
power-cycle the terminal and select the minimum DOS prompt from
the boot menu.
2 Rename or delete the AUTOLOG.SCR file.
3 Reboot the terminal again and allow it to complete the boot into termi-
nal emulation.
59XX, 17XX, 11XX Terminals
To disable auto-login on a 59XX, 17XX, or 11XX Terminal, reload the
terminal with unmodified flash, then perform a cold start to flush the me-
mory. The flash file does not allow selective erasing; files can be added, but
not removed without r emoving all files.