Extended Commands—Chapter 7
315TE 2000
5250 Terminal Emulation Programmer’s Guide
Example of Set Parameters
This example and chart show data for Set Parameters. Note that “b”indi-
cates a 1-byte space.
b#H099bbb4b11b0255022002010080
Column 1 Column 19Column 11 Column 28
Column Character Description
1 b This column typically contains a space.
2 # Extended command.
3 H Set Parameters command.
4–6 099 Backlight stays on for 99 seconds.
7–9 bbb No change from current (legacy RT3210 Terminal only)
10 4 Cursor is in block blink mode.
11 b No change from current setting.
12 1 Remote display is in use (17XX, 11XX Terminals).
13 1 Stream sc a nning is enabled
14 b No change from current se tting
15 0 Beep is disabled on keyboard error
16–18 255 Beeper volume is set at 255
19–21 022 Beeper frequency setting is set at 22
22–24 002 Beeper length is 2 seconds
25–27 010 Number of rows in primary screen size is 10
28–30 080 Number of columns in primary scre en size is 10
To Next Page
Loading...
