Using the Terminal Emulation Menus—Chapter 4
105TE 2000
5250 Terminal Emulation Programmer’s Guide
1) Set-up Parameters
The following setup parameter information pertains to all terminals unless
otherwise noted.
1) Communication
The communication option for the terminals are broken down as follows:
S 2415, 2425, 2435A, 2455, 2475, 248X, 5020, 700 Series, CK30,
CK31, CV60 with UDP Plus
1) ITC Server via the next paragraph.
S 2415, 2425, 24 35A, 2455, 2475, 248X with RTC
2) RTC/WTP on page 107.
S 6400, 5055, 59XX, 17XX, 11XX with RT C
2) RTC/WTP on page 109.
S 6400, 5055 Terminals with TCP/IP
3) Direct Connect on page 111.
S 2415, 2425, 2435A, 2455, 2475, 248X, 5020 with TCP/IP, 700 Series,
CK30, CV60
3) Direct Connect on page 113.
1) ITC Server (2415, 2425, 2435A, 2455, 2475, 248X, 5020 with TE/UDP Plus,
CK30, CK31, CV60)
ITC (Intermec Technologies Corporation) Server options are as follows.
To set the options, select 1) ITC Server, 2) Host/Srvr, then the Server
Setup option (Server A, B, or C).
1) Host Name
2) Upline Prot
3) Port Number
4) Emulation
Server <A, B, or C>
Server IP
<IP address>
Server Setup
1) Server A
2) Server B
3) Server C
ITC Server
1)
2) Host/Srvr
[1]
Controller Type
1) ITC Server
2)
3)
[2]
To Next Page
Loading...
