Extended Commands—Chapter 7
305TE 2000
5250 Terminal Emulation Programmer’s Guide
Example of Transmit and Receive
The following example and chart show what would be sent to a terminal to
causedatatobetransmittedandreceived.Note that “b” indicates a 1-byte
space.
b#F4N81bb000b500A0102bb10
This is data to send.#
Column 1 Column 23
Line 1
Line 2
Column 11
Column Character Description
1 b Th i s column typically contains a s pace.
2 # Extended command.
3 F Trans mit and Receive command.
4 4 9600 baud.
5 NNoparity.
6 8 Eight data bits.
7 1Onestopbit.
8 0 No CTS flow control.
9 0NoDTRflowcontrol.
10 0 No XON/OFF flow control.
11–12 00 No flow control timeout value.
13 b AID key is Enter.
14–15 50 Receive a maximum of 50 characters.
16–17 0A Delimiter character is 0A hexadecimal (line feed).
18–19 01 Data will be sent to host after 1 delimiter character is received.
20–21 02 Start character is 02 hexadecimal (STX).
22 b Start character will not be returned.
23 b Do not flag parity e rrors.
24–25 10 Receive timeout length is 10 s econds.
To Next Page
Loading...
