Intermec CK30

Using the Terminal Emulation Menus—Chapter 4
115TE 2000
 5250 Terminal Emulation Programmer’s Guide
2) Barcode Parms (6400, 5055, 59XX, 17XX, 11XX, 700 Series, CK30, CK31,
CV60)
Selecting 2) Barcode Parms displays either the Scanner Type menu or the
Scan Options menu, pending on your terminal:
S For the 6400, 5055, 59XX, 17XX, 11XX Terminals,
Selecting 2) Barcode Parms displays the Scanner Type menu.
S For the 700 Series, CK30, CK31, CV60 Terminals,
Selecting 2) Barcode Parms displays the Scan Options menu.
Scanner Type (6400, 5055, 59XX, 17XX, 11XX)
UsetheScannerTypemenutodesignatethetypeofbarcodescanner.To
make a selection, press the numeric key corresponding to the desired op-
tion, then press [Enter] to access the Scan Options menu.
Note:If1) No Scanner is chosen, the remaining scanner and bar code op-
tions can be set. Then, if a scanner is used at a later time, only the scanner
type needs to be designated. Selected options are highlighted on the dis-
play. Press a key corresponding to that option to deselect a selected option.
Scanner Type
1) No Scanner
2) Wand
3) Laser
4) Wand Emulate
5) Auto Detect
2) Wand,
4) Wand Emulate, and
5) Auto Detect
are for 59XX, 17XX, 11XX
Scan Options
Use the Scan Options menu to assign scan options, enable bar code
symbologies to use (the terminal can only decode the enabled symbologies),
and set options for each enabled bar code symbology, such as the bar code
lengths. Press [Enter] to advance to other Scan Options menus.
Scan Options
1) Redundancy
2) MOD 10 Check
3) Concatenate
4) BC Type Char
5) Stream Scan
6) Scan All Flds
7) More
1) Redundancy is for 6400, 59XX, 17XX, 11XX
4) BC Type Char is for
6400, 59XX, 17XX, 11XX, 700 Series, CK30,
CK31, CV60
3) Concatenate is for 6400, 5055, 700 Series,
CK30, CK31, CV60
1) Redundancy (6400, 59XX, 17XX, 11XX)
This option requires two identical scans of a bar code, one right after
another, before the terminal accepts the scan as valid.