Intermec CK30

Using the Terminal Emulation MenusChapter —4
170 TE 2000
 5250 Terminal Emulation Programmer’s Guide
6) Exit Menus
Note: If direct connect is u sed, the terminal may r eboot upon exiting the
TE configuration menu.
Use 6) Exit Menus to exit the TE configuration menus. If you changed
any parameter settings, the terminal displays the following when you exit
the menus.
Save Parms
Enter ’Y’
to save parms
If you press [Y] (“yes”), you are prompted for a password. “cr52401” is the
default password.
Save Parms
Enter
Password
> .......
After you enter the correct password, your settings are saved to Flash, and
the terminal may reboot. (Some changes automatically reboot the termi-
nal.) If you press a key other than [Y], you exit the menus and the new
settings are not saved. In this case, the new settings are lost when you
reboot your terminal. When you exit the TE configuration menus, the fol-
lowing information appears:
<TE program name> <version>
Session: <number>
Host:
<data stream>