Intermec CK30

Extended Commands—Chapter 7
313TE 2000
 5250 Terminal Emulation Programmer’s Guide
Set Parameters (#H)
Note: This extended command is supported only on 6400, 5055, 59XX,
17XX, and 11XX Terminals. Some parameters do not apply to all terminal
models. See the terminal’s user manual for applicable parameters. “b”indi-
cates a 1-byte space.
Use Set Parameters to set TE configuration parameters (part of the conf ig-
uration menus) that you would otherwise set at the terminal. Set most of
the parameters once per terminal. You can set them when you install a net-
work or when you add terminals to the network. Unless the terminal fails
(perhaps a dead battery) or a user does something destructive (such as a
RAM test), you probably will not need to set them again.
Set Parameters Characters — Line 1, Columns 2–36
(6400, 5055, 59XX, 17XX, 11XX Terminals)
Column Description Character
2 Extended command #
3 S et Parame t ers command H
4–6 Backlight time r bbb=No change from current setting; 000=On continuously;
001–255=Seconds to remain on
7–9 Sleep timer delay (legacy RT3210) bbb=No change from current setting; 000=Off;
001–255=Seconds of inactivity before sleep
10 Cursor mode b=No change from current setting, 1=Underline (default); 2=Under-
line blink; 3=Block; 4=Block blink
11 Screen mode b=No change from current setting; 1=Center curs or; 2=Corner;
3=Page
12 Remote display (17XX, 11XX) b=No change from current setting; 0=Not attached; 1=Attache d
13 Stream Scan b=No change from current setting; 0=D isable; 1=Enable
14 Scan All Fields b=No change from c urrent setting; 0=Disable; 1=Enable
15 Operator error mode b=No change from current setting; 0=Disable bee p on keyboard error.
Operator must press [RESET] after an error.
1=Enable beep on keyboard error. Emits th e e rror tone, then resets
the terminal so t he operator can correct the error.
16–18 Beeper volume bbb=No change from current setting (Default = 255)
000–255=Range of volume from quiet to loud.
19–21 Beeper frequency bbb=No change from current setting
000–030=Frequ ency range from low to high.
22–24 Beeper length bbb=No change from setting; 000–255=Duration in s econds
25–27 Primary screen row size bbb=No change from current setting; 000–255=Number of rows per
display screen
28–30 Primary screen column s ize bbb=No ch ange from current setting; 000–255=Number of columns
per display screen
31–33
Alternate screen row size
bbb=No change from current setting; 000–255=Number of rows per
display screen
34–36
Alternate screen colu mn size
bbb=No change from current setting; 000–255=Number of columns
per display screen