Extended Commands—Chapter 7
309TE 2000
5250 Terminal Emulation Programmer’s Guide
Example of Transmit Only
The following example and chart show what would be sent to a terminal to
cause data to be transmitted. Note that “b”indicatesa1-bytespace.Fol-
lowing the example is an explanation of Line 1.
b#P3N81bb005A
This is data to send.#
Column 1
Line 1
Line 2
Column 11
Column Character Description
1 b This column typically contains a space.
2 # Extended command.
3 P Transmit Only command.
4 3 4800 baud.
5 NNoparity.
6 8 Eight data bits.
7 1Onestopbit.
8 0 No CTS flow control.
9 0NoDTRflowcontrol.
10 0 No XON/OFF flow control.
11–12 05 F low control timeout is 5 seconds.
13 A AID key is [F1].
To Next Page
Loading...
