Intermec CK30

Using the Terminal Emulation MenusChapter —4
172 TE 2000
 5250 Terminal Emulation Programmer’s Guide
If an error is made or the incorrect password is entered, the terminal will
return to 2) Save Parms screen without saving your entries.
Save Parms
Enter
Password:
>.......
Save Parms
Working
Please Wait
........
3) Cloning Opts (59XX, 17XX, 11XX)
Note: 3) Cloning Opts is disabled for 59XX Terminals.
These options transfer the application program or parameter settings from
one terminal to another. All three choices are password-protected, with
“cr52401” as the default password. To perform this function you need a
cloning cable and both terminals set for cloning.
Cloning Opts
1) Clone Prgms
2) Clone Parms
3) Receive Parms
1 Connect the two terminals together using the cloning cable. Use cable
P/N: 216-911-001, with radio terminals containing 12-volt Flash (see
illustration on page 173) for connecting with the NC1100 Power Supply
and Charger (see illustration on page 173).
2 Plu g the NC1100 Power Supply and Charger into an ac outlet. Use
cable P/N: 216-909-001, with radio terminals containing 5-volt Flash.
You may use the 12-volt Flash cable, but this is optional.
3 Turn on the source terminal from which to copy the application.
4 Press 3) Cloning Opts,then1) Clone Prgms.
5 Key in the password.