Intermec CK30

Using the Terminal Emulation Menus—Chapter 4
143TE 2000
 5250 Terminal Emulation Programmer’s Guide
6) Exit TE2000 (700 Series, CK30, CK31, CV60)
This returns control to the Windows operating system. The 700 Series and
CV60 Terminals prompt you for a password before displaying the Exit
dialog. Either press [Y] or tap Yes to exit the TE 2000 application and
return to the Windows operating system.
Exit TE2000
Enter ‘Y’
to Exit TE2000
CK30 700 Series, CK31, CV60
7) More
7) More provides the following additional setup parameters:
Set-UP Parms
1) Menu Password
2) Print Device
3) COM Select
2) Print Device is for 6400, 5020,
700 Series, CK30, CV60
3) COM Select is for 248X, 5055
1) Menu Password
This parameter enables menu password protection for the TE configura-
tion menus. This provides added protection because once enabled, the
password must be entered before any further activity can occur within the
terminal emulation menu screens. The default is to have this option dis-
abled.
To enable the password, press [1], then type “3193693” for the f ixed pass-
word set by Intermec Technologies Corporation. The“1)”willchangeto
reverse video to indicate it is enabled. With this enabled, enter this password
when you access the terminal emulation menu screens. Press [Enter] until
you reach the Main Menu, then press 6) Exit Menus to return to the main
terminal screen.
To disable the password, press [1] to display in normal viewing text. You
do not need to enter a password to disable this function. Note that the
menu password can be set via a custom configuration. See Chapter 5, “Cus-
tomizing Your Configuration,” for help on creating a custom configuration file.