Intermec CK30

Using the Terminal Emulation MenusChapter —4
174 TE 2000
 5250 Terminal Emulation Programmer’s Guide
Note: F or 700 Series, CK31, and CV60 Terminals, the following menu ap-
pears after double-tapping the upper-left corner of your display.
4) Session Menu (2415, 2425, 2435A, 2455, 2475, 248X with WTP, 700 Series,
CK30, CK31, CV60 with TCP/IP, 6400, 5020, 5055, 59XX, 17XX, 11XX)
Note: 2415, 2425, 2435A, 2455, 2475, 248X, 700 Series, CK30, and
CK31, CV60 Terminals with UDP Plus do not allow multiple sessions.
4) Session Menu defines different host communication sessions, designates
a “hot key” that switches quickly between sessions, and assigns sessions
customizable host names (or, friendly names).
1) Switch
Use this option to change the current session. The current (or intended)
session must be identified (or designated) before setting Parameters.
2) Set Hot Key (available on units supporting session-switching)
Displays the current hot key. Use the up and down keys to view the avail-
able choices. Press [En ter] to designate a key for the hot key.
3) Copy Setup (password -protected)
For 2415, 2425, 2435A, 2455, 2475, 248X, 6400, 5020, 5055, 59XX,
17XX, 11XX Terminals,thiscopiesparametersfromthebackgroundses-
sion to the current session.
For 700 Series, CK30, CK31, CV60 T erminals,thiscopiesparametersfrom
the current session to the session chosen. The copied data is grayed out
and the chosen session is outlined with a box, like in this example:
Sample screen from CV60 Terminal
4) Session Name (700 Series, CK30, CK31, CV60)
Use this to assign customizable host names (or, friendly names) to each
session. Enter a name for Session 1, then press [Enter] to return to the Ses-
sion Menu. You may use up to 64 characters for each name.
Sample screen from CV60 Terminal