Intermec CK30

Using the Terminal Emulation Menus—Chapter 4
179TE 2000
 5250 Terminal Emulation Programmer’s Guide
S wtppkt
Includes the WTP Packet driver program if a WTP link accesses the
host computer, or
ethdrv and odipkt
Includes the Ethernet and ODI Packer driver programs if a TCP/IP link
and a controller are used to gain access to the host computer.
S 65scn7b -c1
Activates the scanner driver.
S 6500dbcs
Intercepts INT10 and display characters on the display.
S fwp650h0
Activates the terminal emulation program.
Press <Alt>,then[M] on the external keyboard to access the setup menus.
Note: On terminal emulation keyboards, use [Yellow] in place of <Alt>.
For example, to access the Setup Menus, press [Yellow] [M].
Opening the Main Menu
The Main Menu is the first screen displayed when you open the computer
menus. All other menus are accessed from the Main Menu.
To open the Main Menu, press the yellow shift, then the blue shift
(MENU) key. Briefly, these keys generally operate as:
S [Blue] for functions labeled by blue legends above the keys.
S [Green] for functions labeled by green legends above the keys.
S [Yellow] for functions labeled by yellow legends above the keys.
S [Blue],then[Green] shift is CAPS LOCK.
S [Yellow],then[Blue] is Terminal Emulation menus; your particular
emulation software probably treat the keys for contrast control, back-
lighting and other functions differently.
To Exit Emulation Mode and Return to DOS
Do a cold-restart to exit the current emulation program and return back to
the DOS keyboard layout. Press [Y],thenpress[Enter] several times to
arrive at the DOS C:\ prompt. To exit to the beginning of the current
emulation, press and hold [Blue] and [Yellow],andboth[ENT] keys to
do the hard reset.