Intermec CK30

Using the Terminal Emulation Menus—Chapter 4
161TE 2000
 5250 Terminal Emulation Programmer’s Guide
Example
In this example, the toolbar has an “Exit” option, is set to “Session 1,” dis-
plays the RSSI status, and is also set to “Session 2.” Session 1” is definted
to have the session name “CFNK” and Session 2 shows the IP address
“136.179.84.175.”
Exit
Session 1 set
to session name
RSSI
Session 2 set
to IP address
Note:PressDefaults to reset the toolbar to its default values.
3) Beeper Setup (6400, 5055, 59XX, 17XX, 11XX, CK30, CK31)
The 3) Beeper Setup menusadjustthebeepertonesforkeyclicks(presses)
and error conditions. For 17XX Terminals, 3) Beeper Select directs the au-
diooutputtotheinternalbuzzerortoaheadset.
Beeper Setup
1) Key Click
2) Error Tone
3) Beeper select
1) Key Click is for
6400, 5055, 59XX, 17XX, 11XX
3) Beeper Select
is for 6400, 5055, 17XX, 11XX
1) Key Click (6400, 5055, 59XX, 17XX, 11XX)
Use 1) Key Click to adjust the frequency and length (duration) of the
sound made when you press a key.