Using the Terminal Emulation MenusChapter —4
160 TE 2000
5250 Terminal Emulation Programmer’s Guide
S Select “Signal Indicator” to show the RSSI (Radio or Ready Signal
Strength Indicator) which displays the RSSI f r equency retrieved from
the radio module. The RSSI indicator is updated every 200 millisec-
onds. The color scheme is set up as follows.
Color Status of RSSI
Dark Green 100% Excellent
Light Green 80% Favorable
Yellow 60% Good
Orange 40% Poor
Red 20% Bad
S Select “Term IP” to display the IP address of the terminal. If the IP ad-
dress is not known because the DCHP address is not assigned to the ter-
minal, then the literal “unknown” is displayed in this area.
S Select “SIP Toggle” to add a “T” button to your toolbar. Tap the “T”
button to toggle the SIP to its new state without regard to the SIP
Toggle setting in the TE menus.
S Select “Empty” to inclu de a set number of blank pixels on the toolbar.
S Select “New Row” to divide your toolbar into two rows. All items after
the new row then shows the new width of the toolbar in the selected
row. Use the Up and Dn arrows to position where in your current tool-
bar menus you want to split the toolbar.
S Select “Session 1,” “Session 2,” “Session 3,” or “Session 4” to reserve
space on the toolbar to display the session name first if entered or the IP
address or DNS name of the host that to which that session is connec-
ted. Then, tap on this toolbar section to switch to that session. If no ses-
sion name, IP address or DNS name is entered, then space is reserved
on the toolbar and is left empty.
To Next Page
Loading...
