Intermec CK30

Using the Terminal Emulation Menus—Chapter 4
103TE 2000
 5250 Terminal Emulation Programmer’s Guide
5020, 700 Series, CK30, CK31, CV60 Menus
The following menus pertain to the 5020, 700 Series, CK30, CK31, and
CV60 Terminals.
To return to the Main Menu, press [Enter] several times, then select
6) Exit Menus,toreturntotheoperatingsystem.
LCD Parms
1)
2) Screen Size
3) Screen Mode
4) Annunciators
5)
6) Key Uppercase
7) Scroll Window
7) More
Main Menu 2
1) Keyboard Opts
2) Save Parms
3)
4) Session Menu
Tests
1) Peripherals
2)
3)
4)
5)
6)
Set-up Parms
1) Communication
2) Barcode Parms
3) Protocol Opts
4) Display Opts
5)
6) Cold Start
6) Exit TE2000
7) More
[1]
[2]
[4]
[5] [7]
Version Info
Firmware
<TE Program Name>
Version <number>
Date <ddmmyy>
Beeper Setup
1) Key Click
2) Error Tone
3) Beeper Select
[3]
Main Menu
1) Set-up Parms
2) LCD Parms
3) Beeper Setup
4) Tests
5) Version Info
6) Exit Menus
7) More
6) Cold Start is for
5020
6) Exit TE2000 is
for 700 Series,
CK30, CK31, CV60
3) Beeper Setup is for CK30, CK31
7) Scroll Window is
for 5020
7) More is for
700 Series, CK30,
CK31, CV60
1) Set-up Parms (5020, 700 Series, CK30, CK31, CV60)
This is password-protected to prevent u nauthorized users from changing
parameters. For 5020 Terminals and 700 Series, CK30, CV60 Terminals
with T E 2000 application versions older than 8.00, you can customize the
parameter in the CONFIG.DAT setup file to change the password. For
700 Series, CK30, CK31, and CV60 Terminals with T E 2000 application
version 8.00 or greater, you can customize the parameter in the
TE_SETTINGS.INI setup file. See Chapter 5, “Customizing Your
Configuration. ”
Changed parameters apply to the current session. If more than one session
is available, use the 7) More > 2) Save Parms > 4) Session Menu to verify
or change the current session before going to the next session. To open the
1) Set-up Parms menu, press [1], [Enter], then type “cr52401” at the
prompt to access the menus on the next page.